Rep Power: 235

guys i need help....my engine side mount rubber got busted....half of the rubber was falling off already and the engine starts to shake really bad....



its the one on number 6

can i change this my self if i have the right tool? i think all i need is a wrench an a jack right? put me in the right direction guys

thanks

 
Rep Power: 235

bump

 
Rep Power: 0

Can't see your pics but that mount is really easy to remove. Do you have and EX or LX? The LX is easier because there is no ABS module in the way.

That being said, all you need is a 10, 14, 17, and 19mm deep well socket to get the mount off. Eyger just did this. You don't even need to jack up the motor. Should only take about 45 minutes to replace it.

 
Rep Power: 0

Sorry, the 10mm is to move the ABS module out of the way if you have it.

17 and 19mm are to take the actual motor mount bracket off. Once that is off, you use the 14mm socket to remove the three bolts which hold the mount to the frame. Too easy.

 
Rep Power: 235

thanks man...all i need to do i order the mount

 
Rep Power: 0

Yep!