Rep Power: 337

what the heck does this mean?? thats the code i got from my car, but its making it go into limp mode... so my top speed has been limited to 63mph...

now im pretty sure the map sensor is good.. i just changed the o2 sensor...


but any ideas to what might be wrong?

i dont think theres a vacuum leak, at least i dont hear one

 
Rep Power: 452

well thats the problem with your car, what is the code it through out? If no one responds later, I will get my service manual out and give you step by step instructions on what to test. It will be later this evening, I have school and work all day.

 
Rep Power: 337

im not sure which code.. im sure it will turn on again...

 
Rep Power: 337

the code is p0107

 
Rep Power: 337

im going over it again.. and it sounds like it may be a vacuum leak.. but its hard to tell cause of the exhaust... would that cause that code?

 
Rep Power: 0

Did you recently turbo?

 
Rep Power: 452

well PM me later And I will look in my service manual and tell you.

 
Rep Power: 337

no turbo yet.... im slowly but surly putting on the old components...

i think its probablly cause of the cold weather and my SRI.... altho my AIT sensor could be bad too...

cause if i clear the code after the car is warmed up.. it will run just fine... interesting huh?

 
Rep Power: 0

baro sensor? try your Throttle position sensor, and if its that you need a new throttle body, granted mine is in an RSX but that was my problem with that code

 
Rep Power: 337

the tps reads just fine according to my vafc2