Rep Power: 0

Hey 2k1 Civic guys! I'm an RSX Type-S owner with lots of experience doing spring installs, motor mounts and all that other jazz that us performance oriented drivers like.

2k1 Civic's and RSX's are pretty much the same chassis wise. I have all the proper tools and experience and you'll find i'm the cheapest around. I did Jon's EP3 Civic SI's springs last week. Took about 4 hours start to finish mostly because I dislocated my shoulder and it was cold outside. I do these installs in Bedford, MA. Here are some prices on basic stuff:

I've spent a fortune on tools lately so I thought i'd put them to good use and help my fellow Boston RSX'ers by offering to install stuff for cheap. I have all the correct tools to do stuff like the special honda balljoint remover to remove the steering rods so you will not have to hammer it off ghetto style and the experience as well. In addition, I always torque all bolts down to correct spec.

Please help me recoup some of the cost of these tools by paying me a pittance to install your stuff.

Basic stuff:

Spring/strut install: $70 add $20 for Camber kit. Add $15 for rear swaybar change if all done at the same time.
ES Motor Mounts: $50
brake pad change: $40 Add $20 for new rotors
Hondata gasket: $65.
rear swaybar: $25
CV boots: $120

This is only for labor. U supply the parts.
I can perform other tasks as well like change out damaged suspension components, airbox,etc.... PM me if interested. My parents live in Bedford so I usually use there garage to perform mechanic work. Let me help you install your stuff! For newbies out there, if you mess up, you'll spend more on parts than if you have a person that is experienced in installations.

 
Rep Power: 0

Thats cool man. Welcome to the site. Most of the mods we do are relatively simple, but I'm sure some of us can use your help. You should come to our install fests once it starts getting warm.