d16z6 too slow
Thread Starter
Registered!!
Joined: Mar 2011
Posts: 12
Likes: 0
Rep Power: 0 
d16z6 too slow
have all kinds of shtuff done to my hellion, except for cam shaft and the internals of the head. anyone know who or where i can get a nice cam? then if i do that, i will need to do a valve set up too, correct? this motor is high compression, built for nos. but have ot installed or purchased kit yet...
Live for the Twisties
Administrator
Joined: Jun 2010
Posts: 8,580
Likes: 5
From: Langley, BC
Rep Power: 284 
Re: d16z6 too slow
Skunk2 and BC both make good quality cams and head internals. You typically need to upgrade the valves, springs and retainers if you go above a stage 1 cam and add an EMS.
Thread Starter
Registered!!
Joined: Mar 2011
Posts: 12
Likes: 0
Rep Power: 0 Re: d16z6 too slow
so the head work and like a piggy back or controller? what advantages would i have with something like that? just to be able to control when vtec hits or like have full control over air/fuel and all that? anddddd.... know anyones who is selling any of these products??
Registered!!
Joined: Mar 2011
Posts: 2
Likes: 0
From: hinesvillle Ga
Rep Power: 0 Re: d16z6 too slow
BC charges right about 300 for a custom spun cam for a d series. You tell them what you got done and they can make one to your likeing. And they will sell you valves and springs and retainers to go with
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
Styven Szastur
Fuel, Oil, Cleaners & Other Maintenance
4
Sep 23, 2015 05:26 PM
curaze
Mechanical Problems/Vehicle Issues and Fix-it Forum
3
Sep 22, 2015 08:27 AM
Josh 1973
Mechanical Problems/Vehicle Issues and Fix-it Forum
1
Sep 7, 2015 10:10 AM
