Rep Power: 0

I just installed my kenwood excellon reciever. I want to hook up my sirius antenna and reciever and I need to run cable from the radio to the trunk. Only I can't figure out how to remove quarter pannels in the back seat. Is there a place that details how all the pannels come out?

 
Rep Power: 0

run it the same way you would run RCA's or a power wire for your amp.. check out the Do It Yourself Section and it gives you all the details you should need.

 
Rep Power: 417

eh i didnt even bother to take it out, i just ran it through... started from the trunk cause i found it easiest

 
Rep Power: 0

I just got it all in. I ended up just using a fisher. I just had a real hard time gettin in to go through. Cuz it was a big connector and I kept gettin caught on stuff.

 
Rep Power: 0

You really don't even need to remove the panels. When I ran my RCA cables to the trunk for my sub, I basically ran them under the plastic trim right below the door, then when I got to the end and reached the rear quarter panel, the bottom part, closest to the carpet, isn't really anchored down, so you can wedge the cable under that part of the panel, then stuff it in between the seat and the quarter panel, and into the trunk.