Rep Power: 0

I have this amp, these subs, in this box. (Sites for illustration only.) Not too educated with the technical aspects of the amp/sub hookups, but am a real smart guy. There is no manual for the amp since it was made a while ago.

What is the best way of hooking all of this up and getting the most out of it. I know it's not much, but it's what I have for now. I have another amp if hooking wach sub to an amp would help, different brand though, so I think it would sound different. Any help is appreciated.

 
Rep Power: 0

4-channel amp, 2 single voice coil 4ohm subs. bridge 2 channels of one amp for 1 sub then the other 2 for the other.

 
Rep Power: 0

Thanks man, yeah I was thinkin of only using the rear L & R, but then I was reading that I should do what you said brigde the L&R of the rear, and L7R of the front, as long as I have the high pass & low pass right on both front and rear it should be ok, do that sound correct? Will I get better results with that than just using the rear channels? Thanks again.

EDIT:

Or are you saying to use both amps. I've been reading and for sure the eclipse one is better than the other 200w amp, should i still use both, one for each speaker and just adjust the gain so they both sound equal, or do the above with the one amp?