Rep Power: 0

Where can I find a DiY for installing an amp?

 
Rep Power: 0

it's really not that hard. Most amps come with instructions. Basically your amp has a power ground remote and speakers. Run the power to your battery using at least 4 gauge and fuse less than a foot from the battery using the amps recommended fuse type. Ground the amp in your trunk. run the remote wire to the back of your head unit and run a set of quality RCA's from the back of the head unit to the amp. Lastly just connect your speakers to the amp making sure to connect positive to positive and negative to negative. it's that easy. When setting your gains turn your head unit to 3/4 then slowly turn your gain up until it distorts, then back off a hair. Later.

 
Rep Power: 417

i followed this n was able to install my amp.. if you have any questions just post it here...

http://www.crutchfield.com/infolib/S...s-installation