Fern

Ok I had a toggle switch installed that activates my aftermarket fog lights and I was wondering if I could somehow wire in a simple red alarm LED to indicate when the fog's are on/off since mine come on whether or not the headlights are on. Do I just tap the LED'
s pos/neg wires into the switches or what??

Subrage

iTrader: (6)

after the toggle switch splice the wire and put in a 1k ohm resistor ran in parallel with your fogs, then run put an led in series connected to ground after the resistor


12v----V-----fogs
...........|
...........|---resistor--led--ground

the v is the switch

formulad97

You could replace the toggle switch with a toggle that lights up, that might be another option you could look at. Im supprised your fog lights did not come with that kind of toggle switch.

Fern

well it should have come with the switch, but after getting them installed, the guys that did them told me the switch it was supposed to come with was missing.

gotti

iTrader: (6)

just get an LED switch from Radioshack or whatever....it'll be cheaper and easier than wiring in an LED

Fern

This is true. What kind of switch would I need? Is there a specific type??

gotti

iTrader: (6)

Nah, just one that has a ground, a postive feed, and an accessory thing. Its just a 3 pronged switch with an LED on it. shouldnt cost more than $5

Fern

alright thanks gotti

gotti

iTrader: (6)

np, i have quite a few of these switches in my car. They look pretty good