Power lock conversion problems
Thread Starter
Registered!!
Joined: Jul 2006
Posts: 87
Likes: 0
Rep Power: 0 
Power lock conversion problems
Hey! Ok so i started this project today. Converting my manual locks to power. I have done everything but I'm trying to install a switch but i don't think its the right one or something. here are some picture, hopefully someone can give me some incite as to what to do. Im almost posotive that everything is wirred correct. from each actuator to the center area. I had to fuse all 4 wires from all the actuators + and _ then attached them to the 2X 12V battery things.
Wires: From instructions sheet
Red- Fused Constant 12 Volt Positive
Black- Chassis Ground
Green- Green Wire from Actuators
Blue- Blue Wire from Actuators
Orange- Negative Lock Output from Alarm/keyless Unit/switch
Brown- Negative UnLock Output from Alarm/keyless Unit/switch
HELP ASAP!!
Look at the site...OHC upload forum is full or something
cardomain.com/ride/2344812/1
Wires: From instructions sheet
Red- Fused Constant 12 Volt Positive
Black- Chassis Ground
Green- Green Wire from Actuators
Blue- Blue Wire from Actuators
Orange- Negative Lock Output from Alarm/keyless Unit/switch
Brown- Negative UnLock Output from Alarm/keyless Unit/switch
HELP ASAP!!
Look at the site...OHC upload forum is full or something
cardomain.com/ride/2344812/1
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
Youshoe
7th Generation Civic 2001 - 2005
8
May 22, 2015 09:36 PM
