Rep Power: 0

i have a new 2009 civic si and my boyfriend is making a intake for it... metal piping and a cone filter.... he made 2 for his buds 2009 g37 and it looks great but i am worried he could possibly mess up my intake.... what do u think? -nats


....well my CURRENT intake IS plastic.. the one he is making me is a pipe bent at a shop then the o O clamp on both ends with a cone filter so there isnt any plastic at all really.... looks great just wanted to see what others thought THANKS

 
Rep Power: 230

should be just fine, homemade intakes are pretty common

 
Rep Power: 0

I think you are going to suck in a bunch of hot air and make worse power due to the computer pulling timing due to the extra heat.

 
Rep Power: 230

oh no, another believer in plastic

 
Rep Power: 0

....well my CURRENT intake IS plastic.. the one he is making me is a pipe bent at a shop then the o O clamp on both ends with a cone filter so there isnt any plastic at all really.... looks great just wanted to see what others thought THANKS

 
Rep Power: 811

well so long as the pipe is sealed and you have a good filter like aem dryflow, theres no problem. intakes usually dont make that much of a difference anyway. the only thing is make sure he doesnt mess with the MAF sensor because that needs to be there. it depends which part he's adding a pipe to.

 
Rep Power: 280

Gotta agree here. Actually, a lot of custom piping is made. Doubt it will be badass like this custom work though. I have no idea what this engine is sitting in.

 
Rep Power: 0

that looks like a go cart or a dune buggy or something. My bf made a three inch manderel bent pipe with a spectre cotton filter. He fabricated an adapter for the MAF sensor and it didn't throw a code when i test ran it. He only has to fab a bracket to hold it in place and it's done! ill post some pictures of it for you guys to see.

 
Rep Power: 811

cool sounds like it worked.