Exhaust pipe dimensions for 1998 HB DX
#1
Registered!!
Thread Starter
Join Date: Jul 2010
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Exhaust pipe dimensions for 1998 HB DX
My measurements of the stock piping obtained by wrapping measuring tape around the outside of the piping in multiple areas are as follows:
Circumference = 14.00 cm (5.50 in), therefore:
diameter = 4.56 cm (1.75 in)
I was looking for an axle back exhaust for my car but all the aftermarket diameters are over 1.75 inches. If I were to buy a catback exhaust in order to keep the same pipe diameter throughout, what would be a good diameter? Nothing has been added to the car but may add a short ram or cold air intake.
Circumference = 14.00 cm (5.50 in), therefore:
diameter = 4.56 cm (1.75 in)
I was looking for an axle back exhaust for my car but all the aftermarket diameters are over 1.75 inches. If I were to buy a catback exhaust in order to keep the same pipe diameter throughout, what would be a good diameter? Nothing has been added to the car but may add a short ram or cold air intake.
Last edited by WaryDriver; 08-03-2010 at 05:43 PM. Reason: clarification
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
Wankenstein
Suspension Performance Modifications
13
09-26-2023 06:44 PM
Wankenstein
Mechanical Problems/Vehicle Issues and Fix-it Forum
10
09-03-2015 07:01 PM
Wankenstein
Mechanical Problems/Vehicle Issues and Fix-it Forum
17
07-23-2015 11:48 PM
Wankenstein
Mechanical Problems/Vehicle Issues and Fix-it Forum
4
07-14-2015 03:39 PM
Wankenstein
Mechanical Problems/Vehicle Issues and Fix-it Forum
8
07-12-2015 11:54 AM