Rep Power: 0

hey guys. i just installed a lip kit all the way around. my problem is with the rear lip. so i put it on and my exhaust it too high. so i took the exhaust and hangers and it seems to be resting on my rear sway bar and all that metal on the right side where the exhaust goes. it cant be put back because it will burn my lip and i dont want that. the exhaust hole in the lip is about 2 inches lower then the stock bumper.. is there any exhaust out there that fixes this problem or do i have to go to a muffler shop to get a custom one.

p.s. i need a stock looking one, i got pulled over for modified exhaust. anything will help. thanks guys.

 
Rep Power: 389

Just go to a muffler shop and they will bend your current exhaust so its not rubbing or hitting any of the above. Simple as that- cheapest too. You'd probably make it out of there with less then 50 bucks of work.

 
Rep Power: 0

thanks triz. but i already went to the muffler shop. they took a look at it and they are charging me $120. which is crap. becasue i just changed it becasue i got pulled over for an exhaust so i had to get a stock looking one. and that was 140. well the muffler shop told me that i need to get a new axle back. i said cant you just bend the end of the muffler so it fits flush they said no. i dont know what to do

 
Rep Power: 0

anyone?? please

 
Rep Power: 0

dude they should be able 2 heat the pipe alittle and bend it down
thats what they did for me
and they did it for free

 
Rep Power: 0

thats what i figured... dumb muffler shop always trying to charge me extra. ****.. hahah..

 
Rep Power: 224

I had mine mounted for 50 bucks at midas under the table.