Problem Installing CAI

Thread Tools

Search this Thread

Jun 9, 2003

MORON

Thread Starter

Registered!!

Joined: Jun 2003

Posts: 22

Likes: 0

From: West Palm Beach

Rep Power: 0

MORON is an unknown quantity at this point

Problem Installing CAI

Just need some advice, i'm having trouble attaching the breather hose to
the engine body. Any ideas on how to get it all the way on, and what problems might i have
if it doesnt fit flush against the engine body. Any help always appreciated.

Jun 9, 2003

hothondacivic02

Registered!!

iTrader: (1)

Joined: Feb 2003

Posts: 996

Likes: 0

From: lake forest, California, US

Rep Power: 0

hothondacivic02 is an unknown quantity at this point

its just a rubber hose get a razor blade and use a table and cut it straight and flat then it should fit flush

Jun 9, 2003

FallenAngel

Registered!!

Joined: Jul 2003

Posts: 457

Likes: 0

From: Philly

Rep Power: 0

FallenAngel is an unknown quantity at this point

Exactly, I had the same problem when I was installing my AEM

Jun 9, 2003

Boilermaker1

Jap-Euro Fusion

Hey! Look At Me!! I'm a Supporting Member!!

iTrader: (16)

Joined: Jul 2002

Posts: 13,151

Likes: 3

From: Washington DC

Rep Power: 424

Boilermaker1 is a splendid one to behold

Garden shears work well too... as long as they're sharp. Get the hose securely on the breather nipple... its tapered and the hose is smaller than the OD of the nipple. Push it on as far as you can and just make sure you can't easily pull it off... if you get 1/2 way, that should do it.