Exhaust Install
Thread Starter
Registered!!
Joined: Sep 2004
Posts: 320
Likes: 0
From: Las Vegas, NV
Rep Power: 0 
Exhaust Install
What is the right way to install a 3 piece exhaust? I mean where the mid pipe is connected there are holes and I am guessing the exhaust gases are not suppose to leak out but I tried to insert one piece into another as far as possible but it still seems to leak. Any suggestions. I have a HP Racing Jspec Catback Exhaust.
Thread Starter
Registered!!
Joined: Sep 2004
Posts: 320
Likes: 0
From: Las Vegas, NV
Rep Power: 0 What gasket are you talking about? this is one of those mid pipes that connect with a clamp and not bolts. so i guess unless i am missing something I don't know which gasket you are talking about.
Joined: Jul 2002
Posts: 13,151
Likes: 3
From: Washington DC
Rep Power: 424 
If its a clamp connection then put one inside the other and clamp it. However I highly recommend you take that to a muffler shop once the exhaust is intalled and have them weld the clamped joint shut.
up-up-down-down-left-right-left-right-b-a-b-a-start
iTrader: (20)
Joined: May 2002
Posts: 7,785
Likes: 0
From: London, Ontario, Canada
Rep Power: 370 my bad... I was under the impression that you had flanges.
Anyways, Boiler hit the nail on the head... go get it welded together that way you get no leaks.
Anyways, Boiler hit the nail on the head... go get it welded together that way you get no leaks.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
jcb111
SOHC D17Ax non-VTEC - VTEC Engine Swaps
10
Apr 17, 2025 12:24 AM
