HELP! Rotor Install
Post Whore General
iTrader: (8)
Joined: Dec 2001
Posts: 7,704
Likes: 0
From: Cincinnati, Ohio, US
Rep Power: 374 
Drill them out and then replace them.
Or go to a hardware store and get a set of stripped bit set for a drill gun that is make to remove stripped screws. I know Sears sells them. That should work too. But either way you going to have to replace the screws.
Or go to a hardware store and get a set of stripped bit set for a drill gun that is make to remove stripped screws. I know Sears sells them. That should work too. But either way you going to have to replace the screws.
Thread Starter
iTrader: (24)
Joined: Sep 2002
Posts: 2,685
Likes: 0
From: No.VA, Virginia, US
Rep Power: 314 
i figured out a better way (thanx mex)
hammer the phillips screw driver in
and use a clamp wrench to unscrew it
and use a tiny flat head and hammer the sides
of the screw to loosen it
hammer the phillips screw driver in
and use a clamp wrench to unscrew it
and use a tiny flat head and hammer the sides
of the screw to loosen it
u didn't let me come over to do install u *** 
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
CivicsClass101
1st - 5th Generation Civic 1973 - 1995
0
Jul 9, 2015 11:14 AM
