Blower motor not working after I installed new radio
Thread Starter
Registered!!
Joined: Nov 2013
Posts: 4
Likes: 0
Rep Power: 0 
Blower motor not working after I installed new radio
Basically says it all in the title I checked every fuse under the hood and kick panel everything looks great. I have no clue what it could be everything is plugged in no fan motor no lights to the bottom 3 buttons but I still have my hazards I've looked a forum after forum nothing is helping its 27 degrees tonight I need heat. Is there a relay that I should check? This is very annoying I've installed a ton of radios never had an issue before?
Thanks please help
Thanks please help
If you think a good mechanic is expensive, try hiring a bad one
Joined: Dec 2011
Posts: 32,017
Likes: 256
From: Midwest. Aiming about mid-chest
Rep Power: 517 
Re: Blower motor not working after I installed new radio
no lights to the bottom 3 buttons
Just a guess.
Thread Starter
Registered!!
Joined: Nov 2013
Posts: 4
Likes: 0
Rep Power: 0 Re: Blower motor not working after I installed new radio
I used a wire harness and connected everything the right way and you can't mix up the plugs just stumped I have no clue what it could be unless somthing shorted out
35+ Years Driving Japanese Autos
iTrader: (1)
Joined: Mar 2005
Posts: 4,904
Likes: 14
Rep Power: 307 Re: Blower motor not working after I installed new radio
You did re-check the connectors in the pod.... yes ?
If you select rear defrost, does the led light ??
Is your connection to your blower fan and the transistor still intact ??
If you select rear defrost, does the led light ??
Is your connection to your blower fan and the transistor still intact ??
Thread Starter
Registered!!
Joined: Nov 2013
Posts: 4
Likes: 0
Rep Power: 0 Re: Blower motor not working after I installed new radio
The blower fan and transistor are still intact
And when I hit the rear defrost the light does not come on
35+ Years Driving Japanese Autos
iTrader: (1)
Joined: Mar 2005
Posts: 4,904
Likes: 14
Rep Power: 307 Re: Blower motor not working after I installed new radio
Double check Fuse #14(10A) in under dash box. Replace it, spares in lid under hood box.
Leave key at II engine off and move the face/floor/def **** and listen for noises from the dash when doing so.
Leave key at II engine off and move the face/floor/def **** and listen for noises from the dash when doing so.
Thread Starter
Registered!!
Joined: Nov 2013
Posts: 4
Likes: 0
Rep Power: 0 Re: Blower motor not working after I installed new radio
And thank you to everyone else chimed in
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
ORskier
Mechanical Problems/Vehicle Issues and Fix-it Forum
2
May 3, 2015 12:54 PM
tylerginevan
Hybrid Engine/IMA battery system
10
Apr 27, 2015 12:29 PM
Ian SFBA
Interior DIY
0
Apr 25, 2015 02:25 PM
