Rep Power: 0

I can't find it... so help me 7thgencivic.com God.

 
Rep Power: 0

please help....no flaming, cuz there's no DIY for pulleys at all...jus questions and more reviews....

 
Rep Power: 0

good question zell

 
Rep Power: 0

ya if there is a DIY i would like to know pm me please!

 
Rep Power: 0

Install them and just let some curse words out along the way. By the way, make a DIY for us as you go.

 
Rep Power: 0

Ok, you take the old pullys and belts off ok? Now you replace the old pullys with the new ones and then put on the belts. There not that hard to get to if you have small arms. Its really as simple as it sounds there nothing tricky about it. Use a socket wrench [IMG]i/expressions/face-icon-small-smile.gif[/IMG]

 
Rep Power: 0

This is how i did my pulleys. Take off the front bumper, then take off the drivers side head light. With this done it gives u better access to the pulleys, than if u were to go through the plastic in the wheel well. After the head light is out use the belt tentioner (it's a wing nut), tighten the belt and take off the power steering pulley. Then to get at the alternator pulley remove the power steering pump, tighten the alternator belt (wing nut again) and take out the alternator. Then just remove the pulley put the new one on and just reassemble in reverse order to the way u took it off. It took me about 3 hours to do, but that's only cause we took some time away from this cause we were getting mad.

Hope that helps.

 
Rep Power: 0

I've got a DIY that I found on this site, ,but there's no pics, just step by step instructions.

 
Rep Power: 0

what's the link to it???