Rep Power: 0

Got everything done now does it matter if I take off the silicone on the outside of the light, or should I leave a little on there for keeping the headlight from leaking?

Seached and read but couldn't find any information, wanna complete the project today

Nick

 
Rep Power: 0

how much did you put on? You need a lot to keep the seal and if it's clear then you can't see it anyway and you should leave it on.

 
Rep Power: 0

I put on quite a bit, and it ooxed out of the groove a little bit in most areas

 
Rep Power: 0

if there are huge gobs of it you might want to take it off, but if it is clear and just a little bit then it probably doesn't matter.

 
Rep Power: 0

OK yeah its clear and there a few big areas but besides that it doesn't look half bad. When I took apart the Factory headlights they didn't have much that came out, so I definately had more sealant than they put on.

 
Rep Power: 0

if you got silicon on the edges of the hd, just take sharp knife or razor blade and cut it off.....thats what i did, and i have no leaks

 
Rep Power: 0

Ok, going to trim them up and put the car back together we'll see how this goes

Nick

 
Rep Power: 0

Cars in one piece and back together thanks for the help, checking to see if it leaks will come over time.


Thanks again

Nick