F/S 5 lug 11.8" Complete Swap (Without K-series Axles)
Thread Starter
Search and Learn
iTrader: (34)
Joined: May 2002
Posts: 14,004
Likes: 0
From: 909, Socal
Rep Power: 432 
F/S 5 lug 11.8" Complete Swap (Without K-series Axles)
Parts Included
1. Type S 11.8" Front Rotors, Calipers
2. RSX/05 Si Front Assemblies ( Hub with bearings, Knuckles )
Damged Studs.
4. Rear Complete Brake setup. Picked up from Race car.
[Rotors, Hub Assemblies, Knuckles]
[Brand new, zero miles put on: Been sitting, So Bit rusty]
*Missing rear Calipers
Extremly good upgrade.
11.8 " vs 10.2"
Plus Rotors/Pads are cheap to replace compare to ITR DC5 Brembo Swap.
Clears few 15" Wheels (Team Dynamics)
$600 pick up
15/16" RSX Type S Master Cylinder :
$80 optional.
Socal HIGHLY prefered
1. Type S 11.8" Front Rotors, Calipers
2. RSX/05 Si Front Assemblies ( Hub with bearings, Knuckles )
Damged Studs.
4. Rear Complete Brake setup. Picked up from Race car.
[Rotors, Hub Assemblies, Knuckles]
[Brand new, zero miles put on: Been sitting, So Bit rusty]
*Missing rear Calipers
Extremly good upgrade.
11.8 " vs 10.2"
Plus Rotors/Pads are cheap to replace compare to ITR DC5 Brembo Swap.
Clears few 15" Wheels (Team Dynamics)
$600 pick up
15/16" RSX Type S Master Cylinder :
$80 optional.
Socal HIGHLY prefered
Last edited by civicvtec1ps; Jul 4, 2007 at 01:58 PM.
Thread Starter
Search and Learn
iTrader: (34)
Joined: May 2002
Posts: 14,004
Likes: 0
From: 909, Socal
Rep Power: 432 Re: F/S 5 lug 11.8" Complete Swap (Without K-series Axles)
I will see if i can weigh them to get close estimate.
But It would be much easier for local buyers.
Since these thing weigh like 200 lbs front and rear brake setup.
Calipers are 25lbs each.
Rotors are 20lbs or so.
I will get back to you.
Wheels are pending
Any local buyer?
I will cut you a deal!
Good deal.
Rear setup is brand new, wire brush will take care of rear rotor rusts.
Front setup has been removed from 05 Si, low milage.
Calipers has been used for 15k on RSX Type S, along with front rotors.
Brake pads are almost new.
Master cylinder has been removed from 06 RSX S: 15/16" same ones as ITR/CTR's.
Oh yea and I have extra set of brake lines off my si.
You need those for rear conversions.
But It would be much easier for local buyers.
Since these thing weigh like 200 lbs front and rear brake setup.
Calipers are 25lbs each.
Rotors are 20lbs or so.
I will get back to you.
Wheels are pending
Any local buyer?
I will cut you a deal!
Good deal.
Rear setup is brand new, wire brush will take care of rear rotor rusts.
Front setup has been removed from 05 Si, low milage.
Calipers has been used for 15k on RSX Type S, along with front rotors.
Brake pads are almost new.
Master cylinder has been removed from 06 RSX S: 15/16" same ones as ITR/CTR's.
Oh yea and I have extra set of brake lines off my si.
You need those for rear conversions.
Last edited by civicvtec1ps; Jun 29, 2007 at 02:19 AM.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
zcwagon
Archive - Wanted Parts (WTB's)
0
Apr 24, 2015 05:18 PM
supercivic01
General Honda Civic Forum Archive.
26
Jan 26, 2002 10:11 AM
