Rep Power: 257

So, I finally decided it was time to replace my speakers. I thought my passenger side one had blown or something. I hooked up my new speakers to it and surprise, no sound. Nothing. I guess it's the wires or something, unless y'all can think of anything else. I'm thinking about just rewiring those wires, and see how that goes. Or maybe I'll just amp them. I dunno. Any suggestions would be appreciated.

 
Rep Power: 321

maybe the wiring from you headunit is loose or fvcked up.

 
Rep Power: 257

nah, it's a brand new headunit, it did the same thing with my past 2 hu's as well.

 
Rep Power: 301

rewire it with bigger gauge wire for better sound. Thats what i am going to do when i hook my speakers up

 
Rep Power: 277

How did you mount the new speaker in the door? I drilled mine in, and somehow the magnet from the speaker touching the door disabled it (no sound). So I wrapped some foam around it and it works, dunno if this is the case with you however.

 
Rep Power: 811

ya did you use a spacer? have you rolled down the window and had it get stuck? most speaker needs 1 inch spacer to fit properly.

 
Rep Power: 257

no, everythings fine. Today I hooked it up to an amp just for giggles, and the speaker works fine. I guess it's the wires coming from the HU where I can't see. Would y'all suggest running new wires, cause I really am not sure about running my speakers off my amp. Just too much trouble.

 
Rep Power: 811

ya just run new wires. you'll have to even with an amp since the stock ones are bad.

 
Rep Power: 257

I just finished hooking up my speakers to the amp. I found an old 4 channel amp laying around and it'll do for the time being, esp. when I get my new infinity tweeters Thanks for all y'alls help. Oh yeah, I did use the spacer, I also put some dynamat in. I just drilled new holes for the speakers. It sounds really good. I'm running a Rockford Fosgate P2 10 and then the Infinity 6021(I think) they're the reference series.