Rep Power: 0

I was looking over c2i0v0i1c's base map here and his vtec settings look like this:



and mine look like this:



i cannot figure out for the life of me how to get it to look like his setup and hot to configure the high/low settings for it. i ahve the e-manage set to 4-8-e and all. so if someone could help me, i would greatly appreciate it.

 
Rep Power: 0

The newer version of firmware and support tool software use yours. Kevin's are older. Don't waste you time either on VTEC crossover with the E-mangle. The V-AFC2 does a better job.

 
Rep Power: 0

why would i go out and buy a $300 part when i can just configure this to work? im just lookin for info on how to configure the high and low setting with the new version. kthnx

 
Rep Power: 0

You completely missed my point. No one EXCEPT Kevin, who had it done at a shop, has gotten the e-manage blue to control VTEC. All that I can tell you.

 
Rep Power: 379

I kept my VAFC II to control my vtec engagement and that only that. The main reason is because im running an LX ECU, and then had my car tunned with e-manage.

 
Rep Power: 289

Dont bother wasting ur time trying to manage vtec with the emanage blue. Many people here will tell u that.