Rep Power: 327

I've had some people PM me asking if i could make them a Downpipe for thier HKS manifold. So i wanted to check and see how much interest there may be if i were to make a jig and take some measurements to be able to fab up some for some members for a small profit. Feel free to comment positive or negatively

 
Rep Power: 0

If i still had my turbo setup i would be. It took me forever to get my downpipe just right, with my HKS mani. Now i have a k20 so no need.

 
Rep Power: 584

just be careful down the road bc the ultimate factor is that vendorship

 
Rep Power: 273

so apparently I'm not the only one asking.

 
Rep Power: 424

I dunno. I think you'd be better off just posting some basic dimensions and parts list and letting everyone just rig one up. That way its not on your *** if stuff doesn't line up and you'll find yourself making A1 and A2 versions of it.... just seems like a lot of headache over something thats easily fabbed up.

 
Rep Power: 327

I agree, i've replied to a few recent PM's and they said that it would be possible that i could make one for them. But that they also could have one fabbed up locally fairly easily.

 
Rep Power: 350

Depending on your parts cost and construction materials, go for it. I see nothing wrong with hooking people up with good parts for cheap. Especially considering an average custom downpipe runs from 300-450. Like stated above, just keep in mind the vendor status and advertising. Of course, Grey and CapYoda and others sold little custom things without having vendor status, so for one specific part to help people out, I wouldn't see that as an issue. Maybe pm Derek about it and see what he tells you.

 
Rep Power: 327

if i were to persue it i would get vendor status to support the site!