RSX Sway Bar Q'....
Thread Starter
El Pinche Turbo Mexicano
iTrader: (4)
Joined: May 2002
Posts: 1,954
Likes: 0
From: Monterrey, MEXICO
Rep Power: 0 
RSX Sway Bar Q'....
If i replace my stock rear sway bar with a RSX-S sway bar do i nedd to replace the bushing or endlinks??
Is so do i replace the with RSX one or are there aftermaret ones...
Is so do i replace the with RSX one or are there aftermaret ones...
You'll need to use the bushings for the rsx sway bar, ours are too small I believe. You don't HAVE TO replace your endlinks, but if you plan on doing so hit Grey up. I think he's still selling some.
^ yup.. you need the rsx's bushings which should be 19mm.. I didnt need to replace my endlinks but a few members had some problems with them breaking so dont be surprised.. good luck with the install! worth the money and time 
Yes, it's an Acura EL
iTrader: (23)
Joined: Dec 2002
Posts: 8,248
Likes: 0
From: 416-905, Ontario, Canada
Rep Power: 368 
BTW there is also an Energy Suspension polyurethane bushing kit (look for the 19mm application obviously) so if you wanted polyurethane instead of OEM rubber bushings, you can get that. Warning, it gets a little noisier, but polyurethane should outlast rubber. Can't say I noticed a huge gain in performance from switching to it though.
I snapped two sets of endlinks using a 19mm rear sway bar (one RSX, one Neuspeed). By the time I'd switched to my DC5-R sway bar, I had already purchased and installed Grey's endlinks, and I can't be happier with their performance. I highly recommend them, for peace of mind, if anything. I couldn't snap these things if I tried.
I snapped two sets of endlinks using a 19mm rear sway bar (one RSX, one Neuspeed). By the time I'd switched to my DC5-R sway bar, I had already purchased and installed Grey's endlinks, and I can't be happier with their performance. I highly recommend them, for peace of mind, if anything. I couldn't snap these things if I tried.
Joined: Sep 2001
Posts: 3,101
Likes: 0
From: Los Angeles, CA
Rep Power: 0
Originally Posted by gh0st
i'm using my stock endlinks and the energy suspension bushings that telly spoke of...so far my endlinks are still intact
my rsx bar has been sitting in my garage for almost a year now lolz... need to install that thing...
Originally Posted by CivicHX01
then your not driving fast enough on those corners
my rsx bar has been sitting in my garage for almost a year now lolz... need to install that thing...
my rsx bar has been sitting in my garage for almost a year now lolz... need to install that thing...
Autocross Junky
Hey! Look At Me!! I'm a Supporting Member!!
Joined: Oct 2002
Posts: 7,211
Likes: 0
From: Las Vegas, Nevada, US
Rep Power: 380
Originally Posted by CivicHX01
then your not driving fast enough on those corners
my rsx bar has been sitting in my garage for almost a year now lolz... need to install that thing...
my rsx bar has been sitting in my garage for almost a year now lolz... need to install that thing...
I ran the RSX bar for 6 months worth of autocrossing, with the stock endlinks. You dont need to change them for that bar.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
Raiool
Fuel, Oil, Cleaners & Other Maintenance
3
Oct 1, 2015 10:42 AM
juicetayne
Mechanical Problems/Vehicle Issues and Fix-it Forum
2
Sep 30, 2015 11:02 AM
