Rep Power: 0

I want to install 22mm sway bar, guages, rotors and pads and was wondering if any of you know of any places that does install work for low prices? I am located in the el monte, rosemead area. Thanks.

 
Rep Power: 417

the sway bar i would just DIY, its real easy(unless if your car doesnt have a stock one that is).
pads are easy but not sure about rotors. i'm sure any brake shop can do it for under $30.
guages, i think depends what kind

 
Rep Power: 351

Yeah, DIY the sway bar and you can probably do the rotors and pads. Im not sure whether or not there is a DIY on it here on 7thgen. As far as gauges, you might be able to do that yourself dependent upon which one it is and how willing you are to learn about your car.

 
Rep Power: 313

The pads and rotors are easy to do. I did my AEM Big Rotor kit myself its not that hard.
1. Take your wheel off
2. Take out the two bolts holding in the stock caliper (thats the hardest part cause their on tight)
3. Slide your rotor off
4.Brakes are easy to change they just slide off and on from the caliper.
5. Put everthing back in reverse.

 
Rep Power: 313

if not contact "dj02" he does good work at a good price.

 
Rep Power: 309

Anyone think a collision repair shop can install lowering springs while they're at it? My car is getting repaired and I was thinking, "they might as well stick my neuspeeds on while they're working on it."

 
Rep Power: 0

03-04 EX cluster conversion installer right here for all you DX and VP.