DriftR

I did a seach already for all probable causes. The wiring is all good, battery unplugged during install, fuses ok, but the car turns overs but don't start at all. Jumper settings checked. The only thing i didn't do yet was to use my support tool for the emanage. I wanted to install the emanage first before my injectors and what not so I don't need to modify any maps while the injection and ignition wires are connected. Do I have to load a map in first? Or should it still start without it?

03-Acura-1.7-EL

iTrader: (14)

I dont run emanage, so I cant answer your question.
What you can try doing, is to ask this question in "Forced Induction" forums, quite few people could help you there.

TransformedBG

iTrader: (6)

I would say you need to load a map because it will have no ignition timing otherwise.

tfnaaf

iTrader: (2)

no maps are needed, SHOULD run without a map because nothing else has changed. I would recheck wiring. Power ? Ground?

DriftR

I fixed it, I reversed the ignigtion in/out. Tnaff is right no maps are needed.

tfnaaf

iTrader: (2)

glad you figured it out... 3 weeks later but its fixed Good luck on the rest of your project, hope all goes well!