Rep Power: 0

i read from another thread that 22mm aftermarket sway bar will get in the way of exhaust systems, such as tcs. Do you guys know anything about this? I'm not sure if this is true.

 
Rep Power: 0

yes, even some of the 19mm type-s sway does that too, i have that problem. i put some rubber around the sway to prevent the knocking sound

 
Rep Power: 0

is there any aftermarket exhaust that clears the progress 22mm sway bar?

 
Rep Power: 412

Custom exhaust will. I am not sure about the greddy. There aren't many full cat backs, but i think that even Axle backs might get in the way. It is darn frustrating. that is why Grey is putting his bars on first, then getting a custom catback.

 
Rep Power: 349

yea my 19mm bar hits my custom cat back every once in a while

 
Rep Power: 0

dats f**k up

i have a magnaflow and im planing to upgrade my suspension

 
Rep Power: 419

Yep, right on. I have both the front and the rear sway bars installed, so now I can gather up all of the exhaust components and weld myself together something that will clear everything. Hmm... Now that I think about it maybe I should lower the car first? Well, I'll be sure to design everything so that the exhaust has adequate clearance even if the car is lowered.

 
Rep Power: 0

My HKS Hi-Power rear section has plenty of clearance with my 19mm RSX bar.

 
Rep Power: 0

the magnaflow catback and rsx sway work fine. with the car at stock height, i have around 2 inches of clearance. so i'm assuming that once i lower the car, i'll still have adequate clearance between the two.

 
Rep Power: 0

anybody have a greddy evo on their 2k1 coupe with a 19mm type s lower sway bar. I just picked one up and wanna make sure they don't hit or rub.