Rep Power: 0

dumb questin but i have had my b&g coilovers for a long time now but i havent lowered it more than what the installer did now i want to lower it all the way before i sell it this summer but i never found out how to use the wrenches the came with it please help i don't now what direction to turn them or even how they go on........please just awnsers no criticism...thanks

 
Rep Power: 412

right tighty left loosy. the top one goes righty, the bottom ones goes lefty. that will loosen the rings.

 
Rep Power: 299

They usually are hard to get at. Dont be worried, you wont crack em if you do it hard. Just take the adjustment tool and gently tap the end with a hammer to loosten them up.

Eddie

 
Rep Power: 417

ya just jack the car up. if you can't reach it with the wheels on, your going to have to take it off., you should be able to reach it tho. just loosen the perch(those two locknuts), move them lower than tighten them again

 
Rep Power: 299

IMO For saftey reasons, I would take the wheel off.

 
Rep Power: 0

i lost my wrenches I think

 
Rep Power: 0

how much did you get it for and where? i'm planning to get a set.
thanks