Rep Power: 0

Need help guys

Today I was painting calipers. I noticed that when i was tightening the front driver side wheel it was spinning, while someone was pressing brakes.
The passenger side, on the other hand, was very tight when brakes were pressed.

I hope its just the pads, but probobly not. What else should i look for?

Thx.

 
Rep Power: 0

Are the pads squealing when you drive? If not, your pads are fine. I would check to see if your driver side piston is engaging. If it doesn't engage, try bleeding the brakes.

 
Rep Power: 424

Check the right rear (same channel) compare to right rear. Try bleeding the lines, also check for a pinched line if you had the caliper off and didn't hang it, or were wiggling it around a lot while painting it. look for leaking fluid, or pump brakes a few times, see if the piston needed to be pushed back out a little.
The possibilities are endless.