Coolant leaking
Hi, this is my first time on a forum so im not too sure how these work but figured id give it a shot. i have a coolant leak near the driver side, rear side of the engine. i stuck a camera in there to try to see where exactly it was coming from and it appeared to be coming out of a hole that sort of looked like a plug belonged in, and it was coming out in large amounts. does anyone have a clue what this might be? I have done some research and was under the impression that this might be something called a weep hole?
2001 Honda Civic EX Coupe
2001 Honda Civic EX Coupe
Last edited by StockTech; Apr 24, 2018 at 02:03 PM.
OF top 99.5% creator (Formerly of the Puffinblunts variety)
Joined: May 2012
Posts: 3,634
Likes: 109
Rep Power: 210 










Re: Coolant leaking
The water-pump most likely has a weep hole (by design). If it's leaking from there it's time to replace the water-pump. Put a large (spot-free) piece of cardboard (size of engine) under your car and let it run from cold start to operating temp for 20 minutes or more. Check the cardboard to isolate area of leak. If you don't see any leaks put the cardboard back in place during cool down and check again when engine is cold.
Another possibility is the block's drain plug: drains the water-jacket that surrounds the outer pistons walls. It's located near the the driver's side under the intake manifold. It's a large bolt (IIRC 21mm) and has a one time use crush-washer. The washer is most likely the cause if it's leaking from this location . Did anyone do a drain and fill recently and remove that bolt/washer? Cardboard will help identify that location also.
Last edited by Wankenstein; Apr 25, 2018 at 05:17 AM.
Re: Coolant leaking
I don't think these (7th gen) engines have freeze plugs..6th gens don't, anyway.
The water-pump most likely has a weep hole (by design). If it's leaking from there it's time to replace the water-pump. Put a large (spot-free) piece of cardboard (size of engine) under your car and let it run from cold start to operating temp for 20 minutes or more. Check the cardboard to isolate area of leak. If you don't see any leaks put the cardboard back in place during cool down and check again when engine is cold.
Another possibility is the block's drain plug: drains the water-jacket that surrounds the outer pistons walls. It's located near the the driver's side under the intake manifold. It's a large bolt (IIRC 21mm) and has a one time use crush-washer. The washer is most likely the cause if it's leaking from this location . Did anyone do a drain and fill recently and remove that bolt/washer? Cardboard will help identify that location also.
The water-pump most likely has a weep hole (by design). If it's leaking from there it's time to replace the water-pump. Put a large (spot-free) piece of cardboard (size of engine) under your car and let it run from cold start to operating temp for 20 minutes or more. Check the cardboard to isolate area of leak. If you don't see any leaks put the cardboard back in place during cool down and check again when engine is cold.
Another possibility is the block's drain plug: drains the water-jacket that surrounds the outer pistons walls. It's located near the the driver's side under the intake manifold. It's a large bolt (IIRC 21mm) and has a one time use crush-washer. The washer is most likely the cause if it's leaking from this location . Did anyone do a drain and fill recently and remove that bolt/washer? Cardboard will help identify that location also.
Last edited by StockTech; Apr 25, 2018 at 07:11 AM.
Re: Coolant leaking
I hope the previous owner didn't just offload this vehicle to you with a bad head gasket - which is common in these engines. Lots of info for you on failed head gaskets on this site.
OF top 99.5% creator (Formerly of the Puffinblunts variety)
Joined: May 2012
Posts: 3,634
Likes: 109
Rep Power: 210 










Re: Coolant leaking
Post video to you tube and then linkyour YouTube vid here.
"Marge, anyone could miss Canada! All tucked away down there."
Joined: Feb 2016
Posts: 9,637
Likes: 1,283
From: Barrie, ON Canada
Rep Power: 222 






Re: Coolant leaking
Wow, that's leaking good.
Yeah thats the weep hole, do the timing belt and tensioner as well while you're in there (use honda parts)
Yeah thats the weep hole, do the timing belt and tensioner as well while you're in there (use honda parts)
OF top 99.5% creator (Formerly of the Puffinblunts variety)
Joined: May 2012
Posts: 3,634
Likes: 109
Rep Power: 210 










Re: Coolant leaking
Fire your camera-man..lol.
A bit tough to get a reference point form all the camera motion and it's hard to tell if you're above or under the engine from the halfway point onwards in that video. Looks to be the water-pump weephole but a view from underneath would be helpful. Similar to this:
A bit tough to get a reference point form all the camera motion and it's hard to tell if you're above or under the engine from the halfway point onwards in that video. Looks to be the water-pump weephole but a view from underneath would be helpful. Similar to this:
Re: Coolant leaking
lol yeah wasn't the best video but thank you for the suggestions, i think im going to replace the water pump anyways considering the sticker in the engine bay says it should be replaced in about 8,000 miles. ill be sure to update the thread with a better view also. thanks!
okay so i ran into another issue, while replacing the water pump a bolt holding in the water pump has snapped off, i do plan on extracting it but does anyone know where i can purchase new bolts at? i called Oreilly's and Autozone but neither of them had the bolts? where would i be able to buy new ones? or will i have to try to proceed with 3 bolts instead of 4?
Re: Coolant leaking
Looks like there are two different lengths being called out, both are M6 flange bolts (22mm and 30mm in length). Both of the Honda part numbers are below, you will have to decide which you need. You could also go to any hardware store and find an M6x1.0 flange bolt that is 22mm or 30mm long depending on what you need.
M6x22
95701-06022-08
M6x30
95801-06030-08
M6x22
95701-06022-08
M6x30
95801-06030-08
Re: Coolant leaking
Sorry for the long video, skip to around 0:45 to see it.https://youtu.be/S27RjNaBrm4
probably unrelated to your problem.....but your coolant should NOT BE GREEN!
Re: Coolant leaking
Looks like there are two different lengths being called out, both are M6 flange bolts (22mm and 30mm in length). Both of the Honda part numbers are below, you will have to decide which you need. You could also go to any hardware store and find an M6x1.0 flange bolt that is 22mm or 30mm long depending on what you need.
M6x22
95701-06022-08
M6x30
95801-06030-08
M6x22
95701-06022-08
M6x30
95801-06030-08
"Marge, anyone could miss Canada! All tucked away down there."
Joined: Feb 2016
Posts: 9,637
Likes: 1,283
From: Barrie, ON Canada
Rep Power: 222 






Re: Coolant leaking
Should be using Honda coolant which is blue.
You can buy it in pre-mixed jugs at the dealer.
I use normal coolant in my cars but don't tell anyone
You can buy it in pre-mixed jugs at the dealer.
I use normal coolant in my cars but don't tell anyone
"Marge, anyone could miss Canada! All tucked away down there."
Joined: Feb 2016
Posts: 9,637
Likes: 1,283
From: Barrie, ON Canada
Rep Power: 222 






OF top 99.5% creator (Formerly of the Puffinblunts variety)
Joined: May 2012
Posts: 3,634
Likes: 109
Rep Power: 210 










Re: Coolant leaking
OP: when you install the water pump follow the service manual's torque specs and crossing pattern. Also, would be a good time to install a timing belt kit if it's near the scheduled (service manual) mileage/years.
Last edited by Wankenstein; Apr 27, 2018 at 06:36 AM.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
eswar_ner
7th Generation Civic 2001 - 2005
6
Oct 8, 2014 06:12 PM
Lordsin
6th Generation Civic 1996 - 2000
3
Apr 22, 2014 07:36 PM
satown210
Mechanical Problems/Vehicle Issues and Fix-it Forum
8
Mar 2, 2011 05:46 AM
Thrasher086
Mechanical Problems/Vehicle Issues and Fix-it Forum
9
May 11, 2006 11:35 AM
ricergribbs
Mechanical Problems/Vehicle Issues and Fix-it Forum
7
Feb 2, 2005 04:35 PM





