Rep Power: 0

My 01 civic has the dtc P0141 on and can't figure it out . Both 02 sensors are new , check the heater circuit out and have 12v and ground , has there been an issue with the ecms on these cars

 
Rep Power: 518

New from where? What brands of sensors did you install?

You replaced BOTH sensors for this code?
Have you rechecked codes, do you have codes for both sensors now?


Got your original sensors? What brands were they?

 
Rep Power: 0

Bought the car and it had both new sensors in it not sure what make , have a parts car with no codes on it so I changed out both the sensors from the parts car . Still same code , checked and compared the voltage and resistance readings with my parts car . They all check out the same . Thinking it is the ecm . When I watch the live data on my code reader the number never change for the down stream 02 sensor .

 
Rep Power: 518

What year is the parts car?

Ohm test the heater in each sensor. What resistance does each sensor show?
Rear sensor heater should be 10-40 ohms

#4 fuse (10A) in the dash fuse box good?

 
Rep Power: 0

The heater circuit in the sensor is 12.2 ohms , engine is cold , checked all the fuses under dash , fuse 4 under dash says its for the alternator . But it is good

 
Rep Power: 518

I've got one note that says a rear sensor from an 05 tested at 15.6 ohms hot, so that sounds ok.

I personally have not had to replace a PCM for a code like this, but I work at a small dealer.

 
Rep Power: 0

The parts car is a 03

 
Rep Power: 0

Checked the resistance in the heater circuit on the new sensor that came with the car only 7.8ohms

 
Rep Power: 518

That resistance does not sound ok.