1350.00 to much to have input shaft and main shalf bearing done
#1
Registered!!
Thread Starter
Join Date: Apr 2011
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 1350.00 to much to have input shaft and main shalf bearing done
i had a loud noise in first second and third gear the shop i took it too said there are bad bearings in the transmission .tranny fuild is burnt up after one month .is 1350 a good price to replace these bearings i know the parts are only about 150 the rest is labor what do you guys think
#3
Registered!!
Thread Starter
Join Date: Apr 2011
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 Re: 1350.00 to much to have input shaft and main shalf bearing done
no i just put one in resufaced the flywheel and everything .do you know how long it takes to do. The shop charges 105 an hour they havent started working on it yet so maybe i still have a chance to redeem my jugement skills.
#4
Registered!!
Join Date: May 2010
Location: Funkytown, Tx
Posts: 3,662
Likes: 0
Received 2 Likes
on
2 Posts
Rep Power: 210 Re: 1350.00 to much to have input shaft and main shalf bearing done
That's about right. They have to break down the whole tranny to replace those bearings. Not to mention removing and reinstalling it.
#5
PITA Admin
Administrator
iTrader: (1)
Join Date: Dec 2008
Location: TN
Age: 52
Posts: 14,795
Received 1,450 Likes
on
1,204 Posts
Rep Power: 339 Re: 1350.00 to much to have input shaft and main shalf bearing done
make sure you have all checked before it goes in or else it will need to come out again
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
7thgensurvivor
Mechanical Problems/Vehicle Issues and Fix-it Forum
12
08-26-2015 06:17 PM
Kyles24
Overheating or loss of coolant, heater blowing cold
0
07-12-2015 09:15 PM
06Si_Girl
8th & 9th Generation Civic 2006 - 2015
1
07-12-2015 12:08 PM