Rep Power: 0

im going to purchase oem side skirts this weekend...and i've searched the DIY's and can seem to find how to install these because the person im buying from them have the screws but no brackets....so i was just wondering if anybody knew how to install these and can give me a couple of pointers. thx

 
Rep Power: 345

go to your local honda dealership, buy the brackets, and have them print out instructions for you. they are very simple to install.

 
Rep Power: 0

yeah, just use a dry-erase marker and youll be fine. make sure the color-match is ok....i didnt check for that till later, and of course it was off

 
Rep Power: 0

oh ok thax....i have couple of ppl telling me there will be alot of drilling to put on the side skirts

 
Rep Power: 345

there's no drilling at all. don't worry, it's easier than you think.

 
Rep Power: 0

no drilling, but you have to get a U shape bracket from home depot and stick it on the side from 3m doubleside tape, then put the skirt on, screw, and screw the underneat oem brackets then you all set.

 
Rep Power: 0

the oem side skirts are really easy to install. no drilling required. u can find the instructions at http://www.handa-accessories.com/civic/03aeroside.pdf

 
Rep Power: 0

ok thanks alot guys....i really really appreciate u guys helping me out thanks alot !!!!

 
Rep Power: 0

i did the same thing i bought a used OEM kit and it had no screws and i had to spend about $150 at my honda dealership it f'in sucked. but they dont even sell the stupid aluminum plates at all so i had to use extra strength doublesided tape to keep them on an it stays on very well.have a good job installing them its very easy.