Bolt-on Engine Performance Post questions/information about intakes, exhausts, headers, lightweight pulleys or flywheels? It belongs here.

D17A1 D16 Skunk2 throttle body

Thread Tools
 
Search this Thread
 
Old Apr 14, 2017
  #1  
RoseyEm2's Avatar
Thread Starter
Registered!!
 
Joined: Dec 2016
Posts: 102
Likes: 0
Rep Power: 0
RoseyEm2 is an unknown quantity at this point
D17A1 D16 Skunk2 throttle body

I got everything to fit but the TPS sensor is different on the skunk2 throttle body. Could i just cut a pig tail from the junkyard with a d16 TPS? Will it work?
Reply
Old Apr 14, 2017
  #2  
ezone's Avatar
If you think a good mechanic is expensive, try hiring a bad one
 
Joined: Dec 2011
Posts: 32,017
Likes: 256
From: Midwest. Aiming about mid-chest
Rep Power: 518
ezone has a reputation beyond reputeezone has a reputation beyond reputeezone has a reputation beyond reputeezone has a reputation beyond reputeezone has a reputation beyond reputeezone has a reputation beyond reputeezone has a reputation beyond reputeezone has a reputation beyond reputeezone has a reputation beyond reputeezone has a reputation beyond reputeezone has a reputation beyond repute
Re: D17A1 D16 Skunk2 throttle body

Could i just cut a pig tail from the junkyard with a d16 TPS? Will it work?
Electrically they operate the same so splicing a pigtail to get the right connector shell should work fine
Reply




All times are GMT -5. The time now is 05:36 PM.