Rep Power: 0

ok so i have done a complete motor rebuild of an 89 crx si, with the block being a d16a6 and i replaced the head with the 98 y8 head and a p28 ecu. Everything I needed to do the bead swap i got and put on. Car won't start! Can someone please help me with figuring out what I need to do? Can someone send me an actual picture diagram needed for the timing on my set up and all that good stuff please? There's alot of bonch around on the enternet.

 
Rep Power: 229

It turns over though right?

As long as all sensors match the ecu, you chose it should work. (TPS, cam signal, crank signal, map/maf sensor)

Hold the throttle open when you try to start it. If that doesn't work, adjust the distributor.

Also check fuel, spark, and injector pulse.

 
Rep Power: 229

Ps, make sure you didn't forget any grounds, like the ground to the head.