'89 Civic Installing new Electronic Ignition Module
Thread Starter
Registered!!
Joined: Jan 2013
Posts: 2
Likes: 0
Rep Power: 0 
'89 Civic Installing new Electronic Ignition Module I have an '89 Honda Civic. I am replacing the electric Ignition Module inside the distributor cap. It was removed by the previous owner, so I don't know how the wiring is suppose to be reconnected. I have 4 wires: Yellow, 2 yellow/black, 1 green. I can't find in my repair manual how to reconnect the wires. Can anyone help me please?
If you think a good mechanic is expensive, try hiring a bad one
Joined: Dec 2011
Posts: 32,017
Likes: 256
From: Midwest. Aiming about mid-chest
Rep Power: 518 
Re: '89 Civic Installing new Electronic Ignition Module
The wires should naturally lay darn close to where they were originally installed.
And you need to clean your spectacles and clean the wires off. The colors and order SHOULD be:
A white
B blk/yel
C wht/blu
D blue
*From Honda Bulletin 93-028
HTH
And you need to clean your spectacles and clean the wires off. The colors and order SHOULD be:
A white
B blk/yel
C wht/blu
D blue
*From Honda Bulletin 93-028
HTH
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
rcolosi
Mechanical Problems/Vehicle Issues and Fix-it Forum
4
Apr 29, 2015 07:48 PM
tylerginevan
Hybrid Engine/IMA battery system
10
Apr 27, 2015 12:29 PM
twtron
Electrical, Wiring, and In Car Entertainment
6
Apr 17, 2015 12:09 AM
1989, 87, 89, civic, distributor, electric, electronic, eletronic, honda, ignition, install, installation, location, module, problems
