DIY is the 2nd post, not the OP's, he just posted question - 06 Civic - Ball Joints
#1
Registered!!
Thread Starter
Join Date: Jan 2008
Age: 59
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 DIY is the 2nd post, not the OP's, he just posted question - 06 Civic - Ball Joints
Hey everyone. I'm pulling my hair out trying to figure out how to remove the ball joints on my 06 civic. Every puller I have tried doesn't fit for this model type. Has anyone done it and if so, do you have a little video? It seems that on the 8th gens, everything is upside down and almost impossible to break free.
Super frustrating!!
Thanks.
Super frustrating!!
Thanks.
Last edited by sdaidoji; 12-13-2015 at 07:40 AM.
#2
If you think a good mechanic is expensive, try hiring a bad one
Re: 06 Civic - Ball Joints
I'd loosen the nut several turns then smack (hammer) the knuckle to pop the tapered shaft free.
If that doesn't work, then try a joint separator. And a hammer.
If you are replacing the ball joint and don't care about the boot, you can use a pickle fork and destroy the boot.
If you just want to get the knuckle free from the LCA, simply unbolt the bottom part of the joint from the LCA.
If that doesn't work, then try a joint separator. And a hammer.
If you are replacing the ball joint and don't care about the boot, you can use a pickle fork and destroy the boot.
If you just want to get the knuckle free from the LCA, simply unbolt the bottom part of the joint from the LCA.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
bsmiley
7th Generation Civic 2001 - 2005
15
11-23-2015 09:11 PM
cptsnuggle
Mechanical Problems/Vehicle Issues and Fix-it Forum
2
10-21-2015 07:16 AM
CraigW
8th & 9th Generation Civic 2006 - 2015
5
10-13-2015 08:56 AM