Rep Power: 0

Which amp do you thing I should go with....

Boss CX1100M.
http://www.bossaudio.com/main/846#

or....

Kenwood KAC-8105D
http://kenwoodusa.com/Car_Entertainm...iers/KAC-8105D

Both are monoblock amps. I am going to be powering 2 12" Kenwwods with one of these.

 
Rep Power: 353

kenwood.

 
Rep Power: 292

Just by RMS alone, the Kenwood offers 300W RMS, compared to the BOSS 250W RMS
And so far, Kenwood has nice amps.

Hard to say, when you havent listened to either of them

 
Rep Power: 512

what kenwood subs are you going to be powering? That does matter. Both of the amps you posted up are monoblocks, so if you're going to be pushing 2 subs, you're only gonna get.. half of the wattage per sub? Someone fill in the blank.. It's been a while since I've looked at subs vs amp setups..

 
Rep Power: 257

boss is like pyle very cheap get the kenwood.

 
Rep Power: 0

both junk but the lesser of two evils is the kenwood.

 
Rep Power: 0

The boss wont load up on my laptop. Look them up on amazon, or maybe crutchfield. See if people have put up reviews from their experience.

 
Rep Power: 0

Are you dead set on these two amps? As others have said, neither are very good. I am partial to JL's G series amps. They are affordable and put out good clean power. As in most things, you get what you pay for man. Monoblock amps are just that, one channel. Most are rated for a 4 ohm load, or a two ohm load. I'd make sure you set yourself up for future expansion in the power department. For example, my sub amp puts out 600 wrms at 4 ohms, and i'm using a single 10" rated for 600 watts. at 2 ohms my amp delivers 1200 wrms, so if I decide to add another of the same sub, I can. Js.

And don't skimp on the wire!!!