Rep Power: 0

I am really sure the seller on ebay sent me the wrong ones:





My HID kit has hi/lo bulbs but I just wanna get the lo going. The hi is not important.

 
Rep Power: 351

it can work, but u will needa mod it.

but it doesn't look like its designed for the H4 system.

 
Rep Power: 511

it looks like it might fit in the 2 vertical plugs on the h4 harness.. Too bad that would hook it up to the high beam instead of the low beam.

It may be too wide though.

 
Rep Power: 0

I guess I have to cut off the 2-prong connector and crimp a spade for each wire to make it work?

 
Rep Power: 351

wont work. because the left is a positive and the right side is ground for the high beam.





use quick male/female disconnect. google what they are if u dont know.

 
Rep Power: 511

Like I said, too bad it would hook it up to high beams instead of low beams.

 
Rep Power: 0

Well, what I meant is...

Can I not cut off the black connector, and crimp these on:

http://www.highoctanecaraccessories....minal_male.jpg

..then insert the spade for the red to the +12V and insert the soade for the black to the low beam ground?

 
Rep Power: 511

I would rather cut and splice an H4 harness in, but that's just me.
http://cgi.ebay.com/ebaymotors/ws/eB...ht_1422wt_1165

 
Rep Power: 351

yes. those are called "male/female quick disconnectors"

 
Rep Power: 0

Will this work?

http://cgi.ebay.com/ebaymotors/ws/eB...m=250705468044

 
Rep Power: 290

doubt it. looks to be for a positive switched H4, not ground switched like 7th gens. see how the H4 connector has 2 black wires on the high beam pin? they're using that ground somewhere else likely, assuming it's constant.

i was trying to sell my relay harness several months ago and noone wanted it. it had lows, highs, and fogs, all on relays with diode suppressors. i got tired of looking at it laying around so i cut the relays and dual relay bases off, kept those and tossed the wire.