How to run wire to a piller?

Reply Subscribe

Thread Tools

Search this Thread

Mar 12, 2005

patau13

Thread Starter

Big Member

iTrader: (1)

Joined: Apr 2004

Posts: 87

Likes: 0

From: Philly

Rep Power: 269

How to run wire to a piller?

I am still thinking about putting my tweets in the a-piller. but--not real sure how to run the wire up there. Any diy's/advice from people who have done it before?

Mar 12, 2005

gearbox

Premium Member

Hey! Look At Me!! I'm a Supporting Member!!

iTrader: (95)

Joined: Sep 2002

Posts: 51,241

Likes: 20

From: NV

Rep Power: 812

ya there is a panel on the side of the dash when you open the door just below the pillar that pops off. You can run wires from under the fuse box up through there and past the vents to the pillar. The pillar is just held on by clips so you can just yank it off.

Mar 12, 2005

vietstylez

iTrader: (8)

Joined: Oct 2001

Posts: 1,803

Likes: 0

From: dfw, tx

Rep Power: 317

vietstylez will become famous soon enough

dont yank too hard though i broke one of those clips an honda charged me 3 bux for it =(

Mar 12, 2005

K20EQUIPPED

Registered!!

Joined: Jan 2005

Posts: 195

Likes: 0

Rep Power: 0

K20EQUIPPED is an unknown quantity at this point

$3 bux...you got ripped

Mar 14, 2005

coop

Joined: Jul 2003

Posts: 4,528

Likes: 0

Rep Power: 323

wiring can also be run through the grommet that sits between the frame and the door. Not the easiest option, but that is where the stock wiring goes and gives you the most control over it.