Rep Power: 0

Hey
Since I installed new speakers which are bigger than stock ones (6.75"), I had to modify my doors to fit the speakers. Now my question is, how would I go about in turning them back into stock?? Do I have to make a 6.75" to 6.5" bracket thing? or how hard will this be?

thanks in advance

Axel

 
Rep Power: 337

hoefully you didnt cut out the brackets that held in the stock speaker

you could always epoxy the stock speaker in place....

 
Rep Power: 0

Aftermarket stereo shops should have the factory brackets, nothing some silicon and hot glu can't fix. If the hole in the door is too big, use some dynamat extreme and cover the opening, trace the factory speaker template onto the dynamat. Silicone the factory speaker to the dynamat,and you are golden. Remember in the future, unless you are going fully n all out, never cut anything! Retain the factory harnessing, brackets, etc, and use the right equipment!

 
Rep Power: 413

Do what Mystic and I did when I just traded my car in: DUCT TAPE!!