Rep Power: 0

do the rsx seats, fit directly into a 2001 honda civic si (ex coupe for U.S) or does it require modifications, is a DIY? and fairly easy?

 
Rep Power: 348

they dont drop right in

 
Rep Power: 289

you need one more person to sit on the seat while you bolt it. Its possible but requires time. Only 3 out of 4 bolts will fit. It seems sturdy, but 4 would be ideal.

 
Rep Power: 289

this is the wrong place to post about the rsx seats btw.

 
Rep Power: 0

OMG!!!! I keep reading stupid posts about RSX seats. This is directed at people who have their seats gheto rigged.

This is about a 30min to 1 hour install and all you need is either a drill with a 1/2 bit or a small recipricating saw. 3 of the 4 bolts fit exactly, and the 4th one is off by about 1/4 to 1/2 and inch. You need to enlarge the hole in the mounting flange on the seat so that the hole and bolt line up. Then, have someone sit on the seat while you tighten the nut onto the bolt. You need someone to sit on the seat because the carpet and frame rails are very close and without some weight the seat will not sit flat long enough get all the bolts tightened.

To those people that are running around with 3 out of 4 bolts tightened, just wait until you get into an accident and the force of the collision causes your seat to come unattached from the mounting flanges and you get tweaked by the seat belt or worse. This is RICE!!! Take the few minutes to correct your install. If you think that a seat that doesn't sit level or rocks a bit is cool, you are STUPID!!!

 
Rep Power: 301

IBTL

 
Rep Power: 349

Ibtm!

 
Rep Power: 374

bore the rear outside hole out. not hard at all.

 
Rep Power: 316

 
Rep Power: 434

you guys ar eso mean