Rep Power: 0

my car flashed a code that says p1362 which means no signal in tdc 1 sensor circuit.ijust did the timing belt deoes this mean that i set the tdc wrong on the crank or the cam and what does number 1 mean after tdc.

 
Rep Power: 215

1 prob means cylinder 1 and yeah u might not have lined it up properly

 
Rep Power: 0

i was not sure but i have an unorthadox under drive crank pulley and ther are three lines to go from, the line on the right is big and bold .thats the line i used for tdc.was i supposed to line up tdc in the middle of the three linez.my car wont really go that fast at all and dies out at stop. is that what bad timing does.

 
Rep Power: 812

yeah i think the timing is wrong

 
Rep Power: 215

i would say try the middle one... i think the other to r for advancing or retarding ur timing

 
Rep Power: 0

i just redid my timing belt and lined the drive gear up with the arrow on the oil pump and correc t tdc on cam.after i put the crank pulley back on all tdc is lined up good. i started my car and the same thing no good some how.is it possible that one of either the cam sensor or the crank sensor went out

 
Rep Power: 812

its possible the tdc sensor went bad, it is a pretty common problem when doing timing belt change on our cars.