Rep Power: 0

Are there any height adjustment screws for the angel eye headlights. On mine i see two one towards the top and on towards the bottom. Are these the screws for adjusting height? If they are which one is which because they don't really seem do be doing much of anything. Maybe I should just tinker with it some more.

 
Rep Power: 0

I'd say tinker with it some more

 
Rep Power: 0

I have the angel eyes also... i have adjusted mine. i forgot which is which, but what u do is turn on your lights and run about 30-50ft in front of your car and check where the lights are aimed then turn one of the screws, you will see that light change its aim. Now u know which one is for up/down and left/right. this can take a while to get both aimed right, when u turn the screws it does not move the aiming a lot. Just keep on playing with it.

 
Rep Power: 0

that would take forever! not to mention that its difficult to adjust while its installed in the car. please someone figure this out so i dont have to go around with crooked lights!!!

 
Rep Power: 0

you do it with out your bumber off, and remove your projectors to get to the screws, then slide them back in withount screwing them one (be careful, they might slide out) and take a look at there aim.