Rep Power: 0

Having problems removing the front bumper. The four screws well they look like clips on-top of the grill wont come off? I try twisting and turning them, still wont jam out. I also tried using a screw driver to yank it out but afraid to break it. Any help???????

 
Rep Power: 256

insert a screwdriver between the clip and twist.

 
Rep Power: 236

you put a flat head between the two circles and pry up on the middle. Dunno how to describe it better...

 
Rep Power: 273

on the clip you will see a flat spot on both sides.. take a flat head and slide it underneath and just turn the flat head.. Now you have more clips like that underneath the bumper as well.. there is also a screw on both sides by the bumper close to headlight.. Hope this helps you out

 
Rep Power: 0

**** it. Use a die grinder and a blow torch. Don't take any guff from your car. Show it who's boss.

 
Rep Power: 273

hahaha

 
Rep Power: 0

i know where im goin from now on with disassembly question.... foos!!

 
Rep Power: 273

he gives the best advice lol

 
Rep Power: 236

www.handa-accessories.com actually gives instructions now that i think about it. Go to exterior and fog light install.

 
Rep Power: 241

...or get goin' about 60 mph hit a tree and the bumper normally just rolls off...no screwdriver necessary...some replacement parts may be needed to reattach the front bumper....

 
Rep Power: 241

In all seriousness though I just normally use two flathead screwdrivers at the low points on either side of the clip, press the flatheads towards the center of the clip and turn...they normally pop loose!

 
Rep Power: 0

50% of the time, brute force and ignorance works all the time.

 
Rep Power: 0

wouldn't that be a bit extra? lolollllllllllll