Rep Power: 0

Hi
just picked up an Ungo S100 car alarm. I figured out where most of the wiring goes except of a few.

The H1/1 (orange)(-) - it says grounded when armed output??

The H1/3 (White/Blue) - 200mA (-) channel 3 output??

That's pretty much it, I kind of figure out where all the other cables are coming from and where they are by searching other forums, but these 2 wiring i can't seem to figure out.

Please let me know if anyone can tell me where I'd wire these too.

Thanks

Sao

 
Rep Power: 332

grounded when armed provides a ground to a relay when the system is armed, this is typically used for starter kill relays or other arming devices like window roll ups and such. channel 3 output is most likely an auxilary channel for a trunk release or window roll down option, etc.

 
Rep Power: 0

Thanks, okay so basically i don't need to worry about the white blue, so where would I wire the H1/1 Orange (-) to ?

 
Rep Power: 332

negative side of the starter kill relay control windings, assuming you plan on using it.