Rep Power: 0

I am right in the middle of installing my LED washers..... I allready have them put in but I can't find where to put the power wires from my switch through the fire wall.... in pogi's diy it shows where but his is an auto ( i think anyway because where he put it is where my clutch is) so anyway I got wires and crap everywhere so I need help fast....

 
Rep Power: 419

Do a search, type "firewall". There are several threads. The first one seems to have some good information. Actually, wait. I'll post the links. Customization is disabled, so you might not actually get the same results that I am getting.

Where can I run wire through the firewall
I cant get through the firewall !!!!!!! Ahhhhhhhhhhhhh!!! HELP!!!!!
How to cross firewall?

The three above should give you all the information you need.

 
Rep Power: 0

i had the same problem, i have a manual, and the firewall is almost directly behind the clutch, and it is the smallest little hole, it took me foreever and a day to get my wires through it, it is very hard to see, unless there is a lot of light emitting through your car. Good luck man...

 
Rep Power: 0

i would think u could drill a hole and buy a rubber piece to fit.....i have the same problem. right now i have it running threw the fenders and into the hole for the power windows.......u can't see it lol

 
Rep Power: 0

OK ... I got it last night..... I put it in were the blue cable above the throttle cable goes in.... it has a rubber piece around it so from the engine bay I just took a flat head screwdriver and pried the edge open and then twisted the screw driver so it would make a little gap and i stuffed the wires in a little and pulled them through from the inside.