graphics kit removal
Thread Starter
Registered!!
Joined: May 2003
Posts: 353
Likes: 0
From: Ga
Rep Power: 0 
graphics kit removal
I'm wanting to shave my door handles but i have one of the flames from my graphics kit in the way. I was wondering if there is anyway to get that part put back on after it's been taken off or am i just going to have to get a new graphics kit?
Hail to the king baby
iTrader: (3)
Joined: May 2002
Posts: 2,325
Likes: 0
From: NorCal
Rep Power: 315 you'lll have to get a new graphic.
yo can usea heat gun and peal the graphic back, but it will be all streatched out and wil be bublled when you try to re-apply it.
You can go to a sticker/graphics shopf and have them make a portion of the graphic, then
just cut out what you need and match it up with a little bit of over lap..about 2mm.
good luck.
yo can usea heat gun and peal the graphic back, but it will be all streatched out and wil be bublled when you try to re-apply it.
You can go to a sticker/graphics shopf and have them make a portion of the graphic, then
just cut out what you need and match it up with a little bit of over lap..about 2mm.
good luck.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
Wankenstein
Mechanical Problems/Vehicle Issues and Fix-it Forum
8
Jul 12, 2015 11:54 AM
OptimisticWay
Mechanical Problems/Vehicle Issues and Fix-it Forum
2
Jul 10, 2015 04:31 PM
ballmich
Mechanical Problems/Vehicle Issues and Fix-it Forum
0
Jul 9, 2015 11:59 AM
