Molybdenum helps with the break-in process, but when you change your oil...
04-17-2005
#1
I went to prison a boy and came out a man with a sore ass!
Thread Starter
iTrader: (3)
Join Date: Nov 2004
Location: Gallup/ABQ, New Mexico
Age: 37
Posts: 3,112
Likes: 0
Received 1 Like
on
1 Post
Rep Power: 269 
Molybdenum helps with the break-in process, but when you change your oil...
Are their oils with molybdenum in them to seal it even further? Sorry if this is an idiotic question, just want to enhance my limited knowledge.
04-17-2005
#3
O RLY
Hey! Look At Me!! I'm a Supporting Member!!
iTrader: (1)
Join Date: Dec 2001
Location: Milwaukee, Wisconsin, US
Age: 44
Posts: 10,031
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 375 From the factory, manufacturer's use their OEM oil plus several addatives including molybdenum (i believe it's molybdenum disulfide) to help the engine break in properly. You want to leave this oil in for a good 5000 miles before you change it out. Once you're past the breakin, you really don't need the amount of molybdenum in your oil that was in it from the factory. There are moly addatives you can get out there, but even most of them say "beneficial to newer engines" on the bottle. Soluble molybdenum is used during the breakin to assist in the amount of heat the engine is producing. (a new engine runs at a somewhat higher than normal operating temperature during breakin) Moly helps dissipate that heat, as well as smooth out the surfaces of everything in the engine during the breakin period.
So just use whatever oil suits your needs best, and IMO, dont worry about adding molys.
So just use whatever oil suits your needs best, and IMO, dont worry about adding molys.
Last edited by S2000man01; 04-17-2005 at 06:45 PM.
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
thana
Overheating or loss of coolant, heater blowing cold
11
06-15-2020 07:05 PM
andjosaus
I.C.E. (Audio) & Electrical Upgrades
4
04-28-2015 10:02 PM
