Rep Power: 0

I want to get the Angel Eyes Halo Projectors from www.rsversion.com and i was wondering what blubs do i need for it? and do i have to change any wiring for it to work. Someone please help me i searched for over 1 hr and i want to know before i order them. THanks a lot guys

 
Rep Power: 306

h1 for low and high beam, and 7443 and 168 i believe. Im not sure which one is for turn or parking light. Yea, some wiring has to be done to connect ur halo's, nothing serious though. You should be ok.

 
Rep Power: 0

so i need to get 4 h1 bulbs total?

 
Rep Power: 306

yup, 2 for low beam, and 2 for high beam

EDIT: BTW, y dont you get them off e-bay??? They're cheaper, thats where I got mine. I seen them go for like 130$

 
Rep Power: 0

DOES ANY ONE KNOW WHAT I NEED TO CONNECT THE ANGEL EYE WIRES TO? I WAS GONNA CONNECT THEM TO THE PARKING LIGHTS IS THAT RIGHT?

 
Rep Power: 306

yea, connect them to your parking lights, thats what I did.

 
Rep Power: 0

aiight thanx, but someone told me that i need to get this little thing and attach it to the positive end( i forget wut its called starts with a "R") so less power goes to the bulb... i have the black angel eye halo projectors, it comes with a black wire and a red one so im not sure wut i have to do.... if any1 knows let me know

 
Rep Power: 0

well i got them and installed them and the drivers side is already fogged up, and both the halos are out. what kind of resistor do i need to prevent this from happenning when i get my replacement halos???

 
Rep Power: 0

pm whelan

 
Rep Power: 0

does any one have a picture of the black angel eye halo projectors on at night, or any picture at all with them on? if so please port them and let me know