junction harness diagram?
#1
Registered!!
Thread Starter
Join Date: Mar 2016
Age: 36
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Rep Power: 0 junction harness diagram?
Any one have a diagram or know where i should look? I just pulled the transmission out of this kids car had it rebuilt and put in a new clutch. I put the car back together drove it around the block and the Junction harness fell down between the CV axle shaft boot and the block and ripped the connector off and all the wires are just hanging I know I could go through and solder or just use butt connectors and what not but I want to do it the right way. This kid had some guy off one of the forums do a swap for him and this the worst swap I've ever seen. Missing 3 bellhousing bolts, torque Mount bolts were missing, distributor held in by one Bolt, hoses all missing from all the EVAP system, the clutch basket bolts were finger tight, the flywheel bolts were finger tight, none of the wiring is on any of the hold down. I don't understand how this kid has been driving it for the last couple weeks without it falling apart. But anyways long story short I'm looking for connector schematic so I can put it back together the way it's supposed to be. I'm also going to be fixing everything else this jackwagon screwed up
Thread
Thread Starter
Honda Civic Forum
Replies
Last Post
steve6
Mechanical Problems/Vehicle Issues and Fix-it Forum
5
11-22-2015 08:18 PM
Othelius
Mechanical Problems/Vehicle Issues and Fix-it Forum
7
10-23-2015 07:25 PM